Pollex is pioneering electrified trenchless infrastructure in Northern Europe

– A milestone towards a sustainable future

Pollex, in collaboration with the water and wastewater unit of Gothenburg (Kretslopp & Vatten), took a major step towards a more sustainable future by undertaking a, for Sweden, groundbreaking project involving electrified pipe bursting in 2025. This marked a significant milestone and demonstrated the potential for a more environmentally friendly water infrastructure. The entire jobsite, including the bursting equipment, excavator, and backfill, were powered by electricity. The pipes used in the project were made from circular materials, further reducing the environmental impact.

 

Electrified vehicles in trenchless renewal

Since then, Pollex has developed a fully electrified solution for trenchless pipeline renovation, using a powerful electric Mercedes-Actros 600, essentially a “giant power bank on wheels” – eliminating the need for external diesel generators.

 

 

The battery’s direct current is converted to alternating current, enabling up to 45 kW of power to be supplied. This is enough to power the entire site, including the pumping equipment, and creates a more efficient, emission-free solution. This solution is not only more environmentally friendly but also quieter and more flexible.

 

“Using a diesel generator, it basically supplies an equal amount of power continuously no matter how much is being used in that moment. A lot of fuel goes to waste. With the battery we only use what we need, when we need it. That makes batteries a more efficient source of energy on-site.”, says Hans Andreasson, Technical Lead at Pollex.

 

A standard project consumes approximately 40-100 kWh, while the vehicle has a 600 kWh battery, leaving approximately 500 kWh for getting to and from the work site, which translates to roughly 500 km.

 

“The vehicle has exceeded all expectations, and it performs flawlessly both on-site and across the country,” says Joakim Lindholm, Regional Manager for Cured-in-Place Pipe (CIPP) at Pollex. With the current vehicle operating from Stockholm as a hub this allows for projects within a 250 km radius from the capital for a single day job.

Out in the field

During a recent project 1.5 hours drive from Stockholm, the eActors 600 was accompanied by a support van and a transport car, both of which were electric vehicles. This was also the case for the winch that was used to pull the new lining into the old pipes. The support van, a Mercedes eSprinter, also has the entire roof covered in solar panels that power the built-in battery system used to run various tools on site. Everything from Pollex on site ran on battery power.

Benefits of electrified no-dig renewal

The electrified solution offers a range of benefits, including:

  • Reduced impact: By avoiding excavation, the project minimizes environmental disruption and reduces the need to transport excavation material.
  • Resource efficient: by not replacing the entire underground network, less new material is needed.
  • Zero direct emissions: The vehicle produces no direct emissions during operation, making it suitable for use in emission zones, urban centers, and protected areas.
  • Low noise levels: Work can be performed at night and in noise-sensitive environments.
  • High energy efficiency: The battery system reduces fuel consumption.

A Future-Proof and Sustainable Solution

The electrification of pipe renewal is a significant step towards a more sustainable future. By combining electric power with trenchless methods, Pollex offers a more efficient, environmentally friendly, and cost-effective solution for water infrastructure. Which is also less dependent on fossil fuels, making it a proponent for regional energy independence.

 

With three more electric installation vehicles on the way, Pollex is pioneering a more sustainable and environmentally friendly future in critical water infrastructure, combining advanced technology with a circular economy.